MITRE Site at Wright-Patterson AFB, OH

The MITRE Corporation
4027 Colonel Glenn Hwy., Suite 310
Dayton, OH 45431
(937) 427-9192

The MITRE Corporation is located approximately 25 miles from the Dayton International Airport, and 4 miles from Wright-Patterson Air Force Base. When traveling to and from the Dayton Airport, it's best to allow one-hour travel time. Air transportation is also available at the Columbus Airport (approximately 60 miles), or the Cincinnati Airport (approximately 75 miles).

Our site office is located at the Signal Hill Techne Center, 4027 Colonel Glenn Highway, Suite 310.

Dayton Airport to Signal Hill Techne Center:

I-70 E to I-675 S. Exit 16 (Grange Hall Road). Turn right at exit ramp. Turn left at first traffic light (Colonel Glenn Hwy.). Turn left at next traffic light into Signal Hill parking lot. Building 4027 is on the left. The MITRE office is located on the third floor (Suite 310).

Directions to offices located at Wright-Patterson Air Force Base:

Dayton Airport to Wright-Patterson Air Force Base, Area A:

I-70 E to I-675 S. Exit 17 (North Fairfield Rd.). Bear left on Route 844 (WPAFB Area A). Exit at Parking Lot 1A. Left on Logistics Ave. Pass & ID (Bldg. 286) is on the left.

Dayton Airport to Wright-Patterson Air Force Base, Area B:

I-70 E to I-675 S. Exit 16 (Grange Hall Rd.). Turn right on Grange Hall Rd., which becomes National Rd. after crossing Colonel Glenn Hwy. Turn left on Kauffman Rd. Turn left on Route 444 (stay in far left lane). Route 444 becomes Springfield Street. Go under the overpass and through first light. Left at WPAFB Gate 1B.

Serving as Architects of Information Advantage.™
Copyright © 1997-2008, The MITRE Corporation. All rights reserved.
MITRE is a registered trademark of The MITRE Corporation.
Material on this site may be copied and distributed with permission only.

Privacy Policy | Contact Us